The TX130+ platform offers customers a single, multifunctional access network diagnostic tool. Equipped with PDH/DSn, Datacom and Ethernet interface options, the TX130+ performs traditional ITU-T/ANSI transmission tests required by large telcos and wireless/mobile operators, Datacom tests for networks operating "V" type interfaces, as well as Ethernet tests for newer, IP-based networks. The TX130+ can also be equipped with ISDN PRI and VF channel analysis.
The TX130+ is designed for field engineers that need an easy-to-use, handheld and battery-powered field unit. To simplify and ensure rapid testing, the unit auto-configures itself to the signal detected, minimizing operator involvement.
Key Features
Supports DS1/E1, DS3/E3, DSn/PDH bit rates
Balanced (120Ω) and Unbalanced (75Ω) interfaces for E1
Balanced (100Ω) and Unbalanced (75Ω) interfaces for DS1
Dual DS1/E1 Transmitters & Receivers for bi-directional testing
Dual DS3/E3 Receiver
Non-intrusive Pulse Mask Analysis at DS1, E1 and E3, DS3 bit rates
Level and Frequency measurements
Auto Configuration of network type, bit rate, line coding, framing, and test pattern
Bit Error and Performance Analysis per ITU/Bellcore standards
Error and Alarm Generation and Analysis
Histogram and Event analysis for errors and alarms
Round Trip Delay on all interfaces
Transmit Frequency Offset to stress clock recovery circuits
DS1 and DS3 Loop capability
Datacom interface for RS-449 (422 and 423), X.21, V.35 and V.36
Synchronous/asynchronous DTE/DCE mode of operation
10/100/1000-T Ethernet Testing for BERT, Throughput, Loopback and RFC2544 in single stream
VF drop/insert by headset
VF frequency/level measurement and VF send tone
ISDN PRI (ANSI and ETSI) call set up
Jitter analysis on all rates, wander analysis on E1 and DS1 rate
